Quicksilver 755SD — System & Component Overview and Operaon
37
The deck plate is a downooding point. When the ski pole is
not in use, verify that the deck plate is properly installed.
Failure to do so may result in injury or death.
Ski Pole
Ski pylon
Deck plate
Stern eyes
Ski pole base
Teak Cockpit Table
Half table
Full Table
20. Ski Pole (oponal)
Your boat may come equipped with an oponal ski pole for water skiing. To use, remove the ski pole
deck plate, located on centerline in front of the motorwell. The ski pylon slides into the deck plate and
connects to the ski tow base, located in the bilge.
The ski tow deck plate has rubber O-ring gaskets to minimize the amount of water that could
potenally enter the bilge. Quicksilver® suggests that prior to installing or removing the ski pylon,
spray water on the ski pole to help slide it through the deck plate.
When the ski pole is not in use, Quicksilver® recommends that you secure the pole in the cabin.
Remove the ski pylon from the base before raising engine to
trailer mode to avoid any damage to the engine cowl.