25
6. Understanding the Analysis Report
a) REPORT DATE - The date that the fluid was analyzed.
b) REPORT NUMBER - The assigned number to this report.
c) CUSTOMER ADDRESS - The name and address of person that this report is being mailed to. This information
is being taken from the sample bottle as it is received.
d) CUSTOMER - The owner of the unit that sample came from.
e) VACUUM PUMP MANUFACTURER - Brand of vacuum pump sample taken from.
f) FLUID TYPE - This should always be QuinSyn
®
, QuinSyn
®
IV or QuinSyn
®
F.
g) SERIAL NUMBER - The unit serial number of the Quincy vacuum pump the fluid sample was taken from.
h) MODEL NUMBER - The model number of the Quincy vacuum pump that the fluid sample was taken from.
i) HOURS ON FLUID - These are the actual hours that the fluid
has been in the unit since the last fluid change.
j) HOURS ON MACHINE - This is the total hours on the vacuum pump hourmeter.
k) SAMPLE DATE - The date that the sample was taken from the vacuum pump.
NOTE:
Items (c through k) are information provided by the service person supplying the fluid for analysis.
Incomplete or incorrect information will affect the report's accuracy.
l) EVALUATION - This is a brief statement made by the technician performing the actual fluid analysis. This
statement addresses the condition of the fluid and filter. This statement will also note any problems that need
attention.
m) PHYSICAL PROPERTIES RESULTS - Particle size is measured in microns.
n) SPECTROCHEMICAL ANALYSIS - See fluid parameters (page 27)
Fluid levels should fill the sight level gauge while the vacuum pump is in operation.
DO NOT OVERFILL
.
Operating over full will result in high fluid carryover.
To Next Page
Loading...
Need help?
General
