To Next Page

To Previous Page

RADIOSHACK 6-IN-1 EASY SETUP VOICE REMOTE

6 Programming Device Control

PROGRAMMING DEVICE

CONTROL

The RadioShack 6-in-1 Easy Setup Voice Remote is

preset at the factory to operate an RCA TV, VCR,

DVD Player, or Satellite Receiver, Pioneer CD Player

and Audio Receiver.

To begin programming device control:

1. Press and hold SETUP until you hear the

programming menu.

2. Press 1. The Programming Device Control

options play:

• “Press one to enter a device code.”

See “Enter a Device Code” on page 6.

• “Press two to search for a device code.”

See “Searching For Your Code” on page 7.

• “Press three to retrieve a device code you

found during search.”

See “Checking The Codes” on page 7.

ENTER A DEVICE CODE

To control devices other than the default brands,

perform the following steps; otherwise skip this

section:

1. Turn on a desired device (e.g.,VCR or DVD

player) and, if applicable, insert media (e.g.,

cassette or disc).

NOTE: Please read steps 2 through 9 completely

before proceeding. Before starting step 2, review

the “Manufacturer’s Codes” (starting on page

30). Brands are listed alphabetically in order of

most popular ones first. Highlight or write down

the devices and the codes you wish to program.

2. Press and hold SETUP until you hear the

programming menu, then press 1.

NOTE: If more than 15 seconds pass between key

presses, the remote says “Goodbye” and exits

programming.

3. Press 1 again.

NOTE: To stop programming at any time, press and

hold BACK.

NOTE: If more than 15 seconds pass between key

presses, the remote says “Goodbye” and exits

programming.

4. At the prompt, press a device key once (i.e.,

CBL/SAT, AUX, TV, DVD, AUDIO, or VCR).

NOTE: Please refer to the “Device Table” on page 5

when choosing a device key for programming.

5. Use the Manufacturer’s Codes (starting on page

30) to locate the type of device and brand

name. At the prompt, use the Number Keys to

enter the first four-digit code for your device.

If performed correctly, the LED blinks twice,

the remote says “Success”.

NOTE: If the LED displayed one long flash instead,

and the remote played “Try again”, a mistake has

occurred and the remote returns to the prompt for

step 4. Try entering the same code again.

6. The remote prompts “Press a test key, such as

power or play. If your device performs the test

function, press Setup to save, or enter the next

code from the manual.” Press a test key.

NOTE: Do not use number keys as test functions. The

remote will think you are entering a different code.

7. If the device performs the test function, press

SETUP to save the code. The remote says

“Success”, and returns to the prompt for

step 3.

NOTE: If the device does not respond, repeat steps 5

through 7 with the next code for your device.

8. Hold BACK until the remote states “Goodbye.”

Aim the remote control at the device and press

POWER once.The device should turn off.

If it does not, repeat steps 2 through 6, trying

each code for your brand until you find one

that works. If it still doesn’t work, try

“Searching For Your Code” on page 7.

9. If the code works, repeat steps 2 through 6 to

program another device or press and hold

SETUP to exit programming.

10. For future reference, write down each working

device code in the following boxes:

CBL/SAT Code: