3
nNote:
• Use only an adapter that supplies 6VDC and delivers at
least 100 mA. Its center tip must be set to positive and its
plug must fi t this indoor antenna’s 6VDC 100mA jack. Using
an adapter that does not meet these specifi cations could
damage the indoor antenna or its adapter.
• Always connect the AC adapter to the antenna before you
connect it to AC power. When you fi nish, disconnect the
adapter from AC power before you disconnect it from the
antenna.
Use Gain Control
Interference on the TV picture might be caused by a
signal that is too weak or too strong.
• Rotate gain control to turn on the gain function. The
green indicator lights up. Adjust gain control until
best picture is obtained.
• Rotate gain control to turn off the gain function. The
green indicator turns off.
To Next Page
Loading...
Need help?
General
