42 Specifications/FCC Statement
6-IN
-ONE
SPECIFICATIONS
Remote Control Power 4 AAA Batteries
Remote Control Dimensions
(H x W x D) 9.38 x 2.79 x 0.69 in.
(H x W x D) 238.3 x 70.8 x 6.9 mm
Remote Control Weight
(without Batteries) 0.36 lb (160 g)
NOTE: S
PECIFICATIONS ARE TYPICAL
.I
NDIVIDUAL UNITS MIGHT VARY
.
S
PECIFICATIONS ARE SUBJECT TO CHANGE AND IMPROVEMENT WITHOUT
NOTICE
.
FCC ST
ATEMENT
This equipment has been tested and found to
comply with the limits for a class B digital device,
pursuant to part 15 of the FCC Rules.These limits
are designed to provide reasonable protection
against harmful interference in a residential
installation.This equipment generates, uses and
can radiate radio frequency energy and if not
installed and used in accordance with the instruc-
tions,may cause harmful interference to radio
communications.However, there is no guarantee
that interfence will not occur in a particular
installation. If this equipment does cuase harmful
interfence to radio or television reception, which
can be deteremined by turning the equipment off
and on, the user is encouraged to try to correct
the interfecnce by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment
and receiver.
• Connect the equipment into an outlet on a cir-
cuit different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio/TV
technician for help.
This equipment has been verified to comply with
the limits for a class B computing device, pur-
suant to FCC Rules. In order to maintain
compliance with FCC regulations, shielded cables
must be used with this equipment. Operation
with non-approved equipment or unshielded
cables is likely to result in interference to radio
and TV reception. The user is cautioned that
changes and modifications made to the equip-
ment without the approval of manufacturer could
void the user’s authority to operate this equipment.
To Next Page
Loading...
Need help?
General
