CHAPTER 1
2 RCM Dry Manure/Litter Setup Guide
AGRICULTURAL CHEMICAL SAFETY
Follow all federal, state, and local regulations regarding the handling, use, and disposal of agricultural chemicals,
products, and containers. Triple-rinse and puncture or crush empty containers before properly disposing of them.
Contact a local environmental agency or recycling center for additional information.
• Always follow safety labels and instructions provided by the chemical manufacturer or supplier.
• Always wear appropriate personal protective equipment as recommended by the chemical and/or equipment
manufacturer.
• When storing unused agricultural chemicals:
• Store agricultural chemicals in the original container and do not transfer chemicals to unmarked
containers or containers used for food or drink.
• Store chemicals in a secure, locked area away from human and livestock food.
• Keep children away from chemical storage areas.
• Fill, flush, calibrate, and decontaminate chemical application systems in an area where runoff will not reach
ponds, lakes, streams, livestock areas, gardens, or populated areas.
• Follow all label instructions for chemical mixing, handling, and disposal.
• Avoid direct contact with agricultural chemicals or inhaling chemical dust or spray particulate. Seek immediate
medical attention if symptoms of illness occur during, or soon after, use of agricultural chemicals or products.
• After handling or applying agricultural chemicals:
• Thoroughly wash hands and face after using agricultural chemicals and before eating, drinking, or
using the restroom.
• Thoroughly flush or rinse equipment used to mix, transfer, or apply chemicals with water after use
or before servicing any component of the application system.
HYDRAULIC SAFETY
When installing or servicing a hydraulic system or hydraulic components, be aware that hydraulic fluid may be
extremely hot and under high pressure. Caution must be exercised.
• Always wear appropriate personal protective equipment when installing or servicing hydraulic systems.
• Never attempt to open or work on a hydraulic system with the implement running.
• Any work performed on the hydraulic system must be done in accordance with the machine manufacturer’s
approved maintenance instructions.
• Care should always be taken when servicing or opening a system that has been pressurized.
• The implement or machine must remain stationary and switched off with booms or implement sections
unfolded and supported during installation or maintenance.
• Take precautions to prevent foreign material or contaminants from being introduced into the implement
hydraulic system. Contaminants that are able to bypass the hydraulic filtration system will reduce performance
and may damage hydraulic components.
• Stand clear of the implement when starting the system for the first time after installing or servicing hydraulic
components in case a hose has not been properly connected or tightened.
WARNING
To Next Page
Loading...
Need help?
General
