Raven RCM User Manual

CHAPTER 2
6 RCM Dry Manure/Litter Setup Guide
MULTIPLE UTS
When an RCM is used in a system with more than one UT (universal terminal), the RCM can be assigned a primary
UT.
FIGURE 1. Set Primary UT Menu
RCM DRY MANURE AND LITTER CONTROLLER OPTIONS
This guide is intended to assist with the setup and configuration of the Raven Rate Control Module (RCM) on pull-
type or self-propelled dry manure and litter applicators.
• Initial Setup and Navigation
• Calibration
NOTE: Prior to using the Raven Rate Control Module control features with any UT display, the Raven Rate
Control Module electronic control unit (ECU) must be calibrated for the control system. Refer to
Chapter 3, Calibration, for assistance with completing the calibration wizard.
This manual assumes that the required control hardware is already installed on supported equipment
and is properly connected. Contact a local Raven dealer for additional information on supported
equipment configurations.

Raven RCM Specifications

General

Brand	Raven
Model	RCM
Category	Control Unit
Language	English