Raymarine SmartPilot S1 User Manual

4
Introduction
This manual describes the service and maintenance procedures for the Raymarine type S1 and S1G Course Computer.
General description
The Course Computer processes information from the sensors in the autopilot system so it can steer the boat using the drive
unit. The Course Computer assembly consists of a plastic case, a printed circuit board (PCB). The PCB carries a
microprocessor, electronic circuitry to control the drive unit, a power amplifier for the drive motor and a connector block for
all inputs and outputs.
Type S1G assembly drawing
1
2
3
6
7
5
4
D8595-1
Item Description
1. Rate giro (Murata)
2. Ring ferrite
3. Connector cover
4. Housing
5. Fuse (Power in) - 15 A
6. PCB assembly
7. Fuse (SeaTalk) - 2 A

Raymarine SmartPilot S1 Specifications

General

Brand	Raymarine
Model	SmartPilot S1
Category	Autopilot System
Language	English