❑ Adjusting the Handlebar Height (E100/E200/E300 only)
❑ Riding Your Scooter
Testing the Brakes – To use the brakes, squeeze the front and back brake levers to increase the
pressure on the brake. The brake lever is fitted with a cable adjuster to compensate for cable stretch
and/or to fine-tune the lever movement to brake engagement. If brake is not engaging properly, follow
instructions for adjusting the brakes on page 5.
Note: The E100 must be going 3 mph before the motor will start. Kick to 3 mph then activate the speed
control while simultaneously pressing the green“go” button to engage the motor.
ASSEMBLY AND SET-UP
1 Pull the quick-release lever
outward.
2 Slide the T-tube to the
desired position and secure by
pushing the quick-release lever.
3 The tension of the quick-
release clamping mechanism
can be adjusted by tightening
or loosening the bolt with
your fingers.
WARNING: Failure
to properly engage the quick-
release clamp may cause the
T-tube to move up or down
while riding, which may cause
you to lose control and fall.
With the quick-release properly
adjusted and engaged, the
handlebars will not move up or
down.
Note: Be careful not to over-
tighten. You should be able
to open and close the quick-
release lever by hand, and the
T-tube should move up and
down freely with the quick-
release open.
4
WARNING: The
brake is capable of skidding
the tire and throwing an
unsuspecting rider. Practice
in an open area free from
obstacles until you are familiar
with the brake function. Avoid
skidding to a stop as this can
cause you to lose control or
damage the rear tire.
Check the Razor web site for any updates on the latest repair and maintenance procedures.
Turn power switch off before conducting any maintenance procedures.
❑ Adjusting the Brakes
REPAIR AND MAINTENANCE
1 To adjust the brake cable
play, thread the brake lever
adjuster in or out 1/4 to 1/2 turn
until the desired brake adjust-
ment is attained. Most
adjustments are complete at
this step. If brake still needs
further adjustment, proceed to
step 2.
2 (E100)
Inspect the brake pads (A)
for proper alignment against
the wheel or excess wear. To
realign brake pads, loosen the
fixing nut (B) and adjust the pad
to contact the rim. Retighten
and test the function, readjust
as needed.
2 (E125, E200 & E300)
If the brake lever adjuster is
threaded outward and the brake
still has too much slack, use the
rear brake adjuster for additional
adjustment.
To Next Page
Loading...
Need help?
General
