EasyManuals Logo
Home>Razor>Scooter>Power Core E100

Razor Power Core E100 User Manual

Razor Power Core E100
12 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #8 background imageLoading...
Page #8 background image
Red
Black
5 Using a pointed object carefully depress the
tabs on the metal pins inside of the motor wire
connector and remove the wires. Carefully pull
wires out from battery tray.
6 Using a Phillips screwdriver remove the three (3)
screws that attach the motor housing to the frame.
7 Using a 13 mm wrench, loosen the outside
locknut (14-6). Use a 13 mm wrench to prevent the
inside nut (14-3) from turning.
Remove wheel/hub motor.
A.
A.
B.
8 To install the replacement wheel/hub motor,
reverse steps 1 through 7.
7
REPAIR AND MAINTENANCE
q Battery Care and Disposal
Do not store in freezing or below freezing temperatures. To properly maintain your battery and ensure maximum battery
life, carefully read the “Charging the Battery” section on page 4 of this owner’s manual.
Pb
Pb
CONTAINS SEALED LEAD ACID BATTERIES. BATTERIES MUST BE RECYCLED.
Disposal: Your Razor product uses sealed lead-acid batteries which must be recycled or disposed of in an
environmentally safe manner. Do not dispose of a lead-acid battery in a fire. The battery may explode or leak. Do not
dispose of a lead-acid battery in your regular household trash. The incineration, land filling or mixing of sealed lead-
acid batteries with household trash is prohibited by law in most areas. Return exhausted batteries to a federal or state
approved lead-acid battery recycler or a local seller of automotive batteries. If you live in Florida or Minnesota, it is
prohibited by law to throw away lead-acid batteries in the municipal waste stream.
q Charger
The charger supplied with the electric scooter should be
regularly examined for damage to the cord, plug,
enclosure and other parts and in the event of such
damage, the product must not be charged until it has
been repaired or replaced.
Use ONLY with the recommended charger.
q Wheels
Wheels and drive system are subject to normal wear
and tear. It is the responsibility of the user to periodically
inspect wheels for excess wear and replace hub motor
components as required.
q Replacement Parts
The most frequently requested replacement parts are
available for purchase at some Razor retail partners. For
the complete selection of replacement parts visit
shop.razor.com.
q Repair Centers
For a list of authorized Razor repair centers:
• Check online at www.razor.com.
• Additional Customer Service contact information is
listed on the back of this manual.
WARNING: If a battery
leak develops, avoid contact with
the leaking acid and place the
damaged battery in a plastic bag.
Refer to the disposal instructions
at left. If acid comes into contact
with skin or eyes, flush with cool
water for at least 15 minutes and
contact a physician.
WARNING: Battery
posts, terminals and related
accessories contain lead and
lead compounds. Wash your
hands after handling.
q Rear Wheel/Hub Motor/Battery Replacement Cont’d
Tools Required: Phillips Screwdriver and Two (2) 13 mm Wrenches
Note:
Motor Control Module
Red
1
Yellow
Black
1
Blue
Note: When re-inserting the motor
wires into the connector, make sure
the red wire connects to the yellow
wire and the black wire connects to
the blue wire.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Razor Power Core E100 and is the answer not in the manual?

Razor Power Core E100 Specifications

General IconGeneral
Battery voltage24 V
FoldableNo
Maximum speed16 km/h
Product colorSilver
Maximum load weight54 kg
Recommended age (min)8 yr(s)
ManualYes
Weight and Dimensions IconWeight and Dimensions
Weight13500 g

Related product manuals