4
Need Help? Visit our web site for replacement parts, product support, a list of authorized service centers in the US and customer service contact information
at www.razor.com. Please have the product I.D. code (located on the white label of your product) available for better assistance. Additional Customer Service
contact information is listed at the back of this manual.
Collar Clamp
Tools required: 5 mm Allen wrench
Using a 5 mm Allen wrench, check that the collar clamp bolt(s) are tightened securely. This item is tightened and quality
inspected at the factory however there is a slight chance that the effects of shipping or handling may have caused the
bolt(s) to loosen.
WARNING:
Failure to properly install and/
or tighten the collar clamp
may cause the rider to lose
control and fall. If you are
having diffi culty understanding
these instructions, please
contact Razor Customer
Service for assistance.
Note: The tension of the quick-
release lever can be adjusted by
manually tightening or loosening
the Allen bolt. Be careful not to
over-tighten. You should always
be able to open and close the
quick-release lever by hand and the
T-bar should slide freely when the
quick-release is open. Unless T-bar
is fully extended.
1 To adjust the height of the
handlebars, open the quick-release
lever and slide the T-bar to the
desired position. Close the quick
release lever to lock into place.
When the T-bar is raised to the
maximum height, depress the
push button located directly
below the quick release lever to
unlock the T-bar.
Adjusting the Handlebar Height
WARNING: Failure to
properly secure the quick-release
lever may cause the T-bar to
telescope up or down while riding
and may cause you to lose control
and fall.
ASSEMBLY AND SET-UP
1 To activate the batteries, locate the battery
compartment underneath the front of the deck and
pull tab out from battery cover.
❑ Activating the Batteries (Spark 2.0 only)
Spark_Series_MAN_US_141117.indd 4 11/17/14 6:23 PM
To Next Page
Loading...
Need help?
General
Weight and Dimensions
