Using Advanced Features
Placing Channels in Memory (Autoprogramming)
20
Only channels 2–13 appear in the TV’s memory when you first turn it on.
The channels available in your area must be programmed into the TV's
memory when you hook up your TV. Using CHANNEL up or down
allows you to scan through these channels.
You may want to add or delete a few channels if some stations have weak
signals or were off the air when the TV was programmed. Refer to the Add
or Delete Channels section on the next page.
A. Hook up an antenna, cable or
components before you begin
these steps or you will not be
able to add channels into
memory.
B. Press MENU•PROG repeatedly
to select the Setup Menu. This
menu is white.
C. Press MOVE H (down) to high-
light Autoprogram.
D. Press MOVE
6
to start placing
channels in memory.
E. Wait until the TV has cycled
through all the channels and
returns to the original channel.
Place channels in memory
(AutoProgram)
13
Controls Alarm Adjust Setup
English
Français Español
Autoprogram
Label 13 clear
Channel Memory: 13 Stored
Cable/Air: Cable
15
Controls Alarm Adjust Setup
English
Français Español
Autoprogramming
Label 13 clear
Channel Memory: 13 Stored
Cable/Air: Cable
To Next Page
Loading...
Need help?
General
