The first step in connecting your TV is obtaining the signal. Your TV has a side panel, which allows you to receive analog and/or
digital television channels via TV jack.
Before connecting your TV, determine using an antenna or a cable service to obtain the signal.
A. Antenna
Connect the antenna to TV via coxial cable on TV jack of the side panel. You are ready to receive air local digital and analog
channels.
B. Cable -rv service
Connect the cable TV wall jack to TV via coaxial cable on TV jack of the side panel. You are ready to receive off-air local digital
and analog channels.
C. Set-Top Box
Ifyou use a set-top box, you may need to call your cable company or satellite service provider, which use a special connection,
please refer to the user's guide of set-top box.
Note: Do not plug the AC cord until you have accomplished all the connections.
AC
100V-240V
50-60Hz
Cable TV Antenna
Or
AC Power Cord
(Connect after all the other connections are done.)
10
To Next Page
Loading...
Need help?
General
