Copyright © 2019 RCA Communications Systems
29Prodigi
TM
RDR1520 Series Professional Digital Two-Way Radio Instruction Manual
Deleting a Nuisance Channel
If a channel continually generates unwanted
calls or noise (termed a “nuisance” channel),
you can temporarily remove the unwanted
channel from the scan list.
Note: This capability does not apply to the
channel designated as the Selected Channel.
This feature is not accessible through the
menu.
1. When your radio stops on an unwanted or
nuisance channel, press the programmed
Nuisance Channel Delete button until you
hear a tone.
2. Release the Nuisance Channel Delete
button. The nuisance channel is deleted.
Restoring a Nuisance Channel
To restore the deleted nuisance channel,
power the radio off and back on again or
press Stop and Start to restart a scan via the
programmed Scan button.
Setting the Squelch Level
You can adjust your radio’s squelch level
to lter out unwanted calls with low signal
strength or channels that have a higher than
normal background noise.
Settings: Normal is the default level. Tight
may help to lter out (unwanted) calls and / or
background noise. However, calls from radio
within your system that are in very remote
locations may also be ltered out.
Press the programmed Squelch button to
toggle squelch level between normal and
tight.
Setting the Power Level
You can customize your radio’s power setting
to high or low for each channel.
Settings: High enables communication with
radios located at a considerable distance from
you. Low enables communication with radios
in closer proximity.
To Next Page
Loading...
Need help?
General
