3
Battery Installation
and Information
Your universal remote requires two new AAA alkaline
batteries (batteries may or may not be included, depending
on the model). To install the batteries:
1. Remove the battery compartment
cover. On the back of the remote, push
down on the tab and lift the cover off.
2. Insert the batteries, matching the
batteries to the (+) and (-) marks
inside the battery case.
3. Replace the battery cover.
Note: Reprogramming may be
required after batteries are replaced.
Congratulations on your purchase of the 3-component
universal remote. This universal remote controls up to three
electronic components and makes juggling remote controls
a thing of the past. You can program this RCA universal
remote to operate most models of most brands of infrared,
remote-controlled components manufactured after 1990.
(See enclosed Code List for a complete list of brands). The
three-component universal remote is easy to use, easy to
program and gives you control at the touch of your fingertips.
Note: The 3-component universal remote is already
programmed to operate most RCA, GE and PROSCAN
branded TVs, VCRs, DVD players and satellite receivers (DBS).
Just press the corresponding component key—TV, VCR•DVD
or DBS•CABLE—and your RCU430D is ready to go!
3 Component
Universal Remote
Key Descriptions
Indicator Light–flashes when a valid key
is pressed to indicate the remote is working.
Status of this light is important when you
are programming the remote.
Component keys
-(TV, VCR•DVD or
DBS•CABLE
): selects the component
you want the remote to operate.
For example, after you’ve programmed the
remote to operate your TV, you must press
the TV key first to put the remote in TV
Mode. While in TV Mode, the CHANNEL
keys change the channel on the TV, the VOL
keys adjust the TV’s volume, etc.
T
ransport keys–REW (Rewind), PLAY, FF
(Fast Forward), PAUSE, STOP: operate
the same as your original VCR or DVD
remote control, although key labels may
vary (REVERSE, FORWARD).
To Next Page
Loading...
Need help?
General
