TV CODE
Program for TV—
Direct Entry Method
1. Manually turn on the TV.
2. Locate the enclosed TV Code List.
Find your brand of TV.
Note: If your brand isn’t listed,
use one of the Code Search methods
to program this remote control.
(See the section on Code Search)
3. Press and hold the CODE SEARCH
key until the indicator light
illuminates. Then release the
CODE SEARCH key.
4. Press and release the TV key.
The indicator light blinks and then
remains lit.
5. Use the number keys to enter
the first code listed for your brand.
After you enter a valid three-digit
code, the indicator light turns off.
Note: If you enter an invalid code,
the LED will flash rapidly for 2
seconds. Start over at step 3.
6. Aim the remote at your TV and press
the POWER key. If your TV turns
off, you have found the correct code.
7. If your TV doesn't turn off, repeat
steps 3-6 above, entering the next
code for your brand.
If none of the codes work or your
brand is not listed, use one of the
Code Search methods to program
this remote. (See the section on
Code Search).
8. With your TV on, press the
CHANNEL UP key. If the TV
responds, no further programming
is required.
Most RCA, GE and PROSCAN
TVs will not require programming.
Check to see if your TV responds
to the remote before you
begin programming.
9. Enter the code in the box provided
on this page for future reference.
In order for the 3 component universal remote to control
your TV, you must program it with the TV code that matches
your TV. These instructions explain the preferred method
of programming the remote—the Direct Entry method. To
program your remote to control your TV, follow these steps:
CODE
SEARCH
INDICATOR
LIGHT
(BLINK)
TV
To Next Page
Loading...
Need help?
General
