ERASE PROTECTION
When you record new material, the cassette deck records over whatever is on a
tape. To protect a tape from accidental erasure, break off one or both plastic tabs
(one for each tape side) on the top of the cassette tape. If you decide later to
record on the tape, seal the hole with a piece of cellophane tape.
Quit Slacking
A little bit of s|ack in your tapes can cause scratches on the tape, or
worse yet, the tape could break. If you notice some slack in the tape,
use a pencil to tighten it up before you insert it.
RECORDING FROM THE RADIO
1. Insert a cassette tape into the tape deck and close door.
2. Move the FUNCTION switch to RADIO and select a radio station.
3. Press RECORD to begin recording. RECORD • and PLAY • lock down.
4. Press STOP/EJECT I/A to end recording.
5. To turn off radio, slide SW_TCH to TAPE.
RADIO RECORDING TIPS
• To temporarily pause the recording, press PAUSE on the cassette deck. Press Pause
again to resume recording.
RECORDING FROM CDS
1, Insert a blank cassette tape into the tape deck,
2. Move the FUNCTION switch to CD.
3. Insert a CD and select the first track you want to record.
4. Press RECORD • and the PLAY • button will automatically engage, the CD will
also start to play automatically.
5. Press PAUSE II to interrupt or edit recording. Press the second time to resume
recording.
6. Press STOP/EJECT I/-- _ to end recording.
I ause for a Moment
Using the PAUSEI| button on the cassette deck instead of the STOP/EJECTbutton to
momentarily interrupt recording gives you a much cleaner recording.
7
To Next Page
Loading...
Need help?
General
