Remove & Close The Lens Cover
Placing Your Projector
Your projector can be installed in four different configurations (see picture below):
5
Remove the lens cover before using
Close the lens cover when unit not using
Front Ceiling
Rear Ceiling
Rear Table
Front Table
Front Table:
Select this location with the projector placed near
the floor in front of the screen. This is the most
common way to position the projector for quick
setup and portability.
Rear Table:
Select this location with the projector placed near
the floor behind the screen.
NOTE: That a special rear projection screen is
required.
Front Ceiling:
Select this location with the projector suspended
upside-down from the ceiling in front of the screen.
NOTE: A projector mount is required to install the
projector in a ceiling.
Rear Ceiling:
Select this location with the projector suspended
upside-down from the ceiling behind the screen.
NOTE: A projector mount is required to install the
projector in a ceiling.
A special rear projection screen is required.
LENS COVER
REMOVE
OK
CLOSE
LENS COVER
OK
To Next Page
Loading...
Need help?
General
