SPEAKERS
To connect a speaker wire either to the terminals of a speaker or the unit,
follow these steps:
1. At theback of a speaker or the unit, press and hold the black tab to open
the (-) terminal, fit in the black speaker wire, release hold.
2. Press and hold the red tab to open the (+) terminal, fit in the red speaker
wire, release hold.
3. Repeat steps 1 to 2 above for connecting to the speakers and the unit.
surround
speakers speakers
ANTENNAS
This unit comes with two antennas: an AM loop antenna and a FM T-type antenna.
Use the same method of connecting speaker wires to hook the AM loop
antenna.To get better reception, try placing it at various locations.
AM Loop
Antenna
As for the FM T-type antenna, it's already attached to the unit, simply extend it
to the full length, then place it at various locations to get clearer reception.
POWER SUPPLY
Plug the power cord into an AC power outlet, be sure to match the wide
blade of the plug to the wide slot of the outlet. If the plug doesn't fit in, try
plugging it the other way, be sure to plug it in completely.
When the unit is off, the STANDBY light comes on showing that the unit is
still plugged to power. To disconnect power completely, unplug the power
cord at the AC power outlet, the STANDBY light goes off.
To Next Page
Loading...
Need help?
General
