9
EN
Radio
Selecting Tuner Band
1. Press SOURCE on the main unit or TUNER on the
remote control to enter Tuner mode.
2. Press CD INFO/BAND to select between AM or
FM Radio band.
Tip: Your audio system has 32 preset stations.
Tuning to a Station
Press SKIP BACKWARD / SKIP FORWARD
on the main unit or TUNING or on the
remote control to select frequency.
Using Presets
The tuner can be in either TUNE or PRESET mode.
When in preset mode,
• Press TUNE/PRESET on the main system or
PRESET or on the remote control to
access the previous or next preset station.
• The display first shows the preset program
number and after a few seconds, the preset
program and frequency will be displayed.
Auto Preset Programming
Press and hold CD INFO/BAND button for 2 seconds
to scan stations in FM band. The stations will then be
stored as preset channels. A maximum of 32 stations
can be stored. Beware of your preset channels being
erased accidentally because the scanning and storing
process is automatic upon pressing the button. You
can stop the automatic scan by pressing any button,
but the erased stations cannot be recovered.
Manually Setting Presets
1. Press SKIP BACKWARD / SKIP
FORWARD to access the desired
frequency.
2. Press the PROG/SET button once.
3. The most recently accessed program location will
flash on the display.
4. If a different program location is preferred, press
SKIP BACKWARD or SKIP FORWARD
on the main unit or PRESET or on the
remote control to move to the desired preset
number (1-32).
5. Press PROG/SET to store the selected frequency
at that preset.
Suppressing Stereo Signal
Press ST/MONO on the main unit or FM ST. on the
remote control to toggle between FM mono and
stereo for stereo FM stations.
PR 01 FM
07 87.90
PROG
MHz
RS2300 EN 7/7/03 11:34 AM Page 13
To Next Page
Loading...
Need help?
General
