EN
8
Radio
Selecting Tuner Band
1. Press SOURCE to select TUNER.
2. Press BAND to select between AM or FM radio
band.
Tuning to a Station
Press SKIP BACKWARD / SKIP FORWARD to
select frequencies.
Using Presets
The tuner can be in either TUNE or PRESET mode.
When in PRESET mode, the PROG light is on.
• Press TUNE•PRESET to toggle TUNE and PRESET
mode.
• Press SKIP BACKWARD or SKIP FORWARD
on the main system or PRESET UP or DOWN on
the remote control to access the previous or next
preset station. The display first shows the preset
program number and after a few seconds, the
frequency will be displayed. (FMPR:01 is FM
preset 1)
Auto Preset Programming
(FM only)
Press and hold BAND button for 2 seconds to scan
stations in FM band. The stations will then be stored
as preset channels. A maximum of 32 stations can be
stored. Beware of your preset channels being erased
accidentally because the scanning and storing
process is automatic upon pressing the button. You
can stop the automatic scan by pressing any button,
but the erased stations cannot be recovered.
Manually Setting Presets
1. Press TUNE•PRESET button to enter TUNE mode.
2. Press SKIP BACKWARD / SKIP FORWARD
to access the desired frequency.
3. Press the PROG•SET button once.
4. The most recently accessed program location will
be displayed.
5. If a different program location is preferred, press
SKIP BACKWARD / SKIP FORWARD
to move to the desired preset number (1-32).
6. Press PROG•SET to store the selected frequency
at that preset.
Suppressing Stereo Signal
Press FM ST. to toggle between FM mono and stereo
for stereo FM stations. (Remote Only)
AUTO
87.50 MHz
PR:01
Tips:
Your audio system has 32 preset sta-
tions.
To Next Page
Loading...
Need help?
General
