12
EN
Radio
Selecting Tuner Band
1. Press SOURCE on the main unit or TUNER on
the remote control to enter Tuner mode.
2. Press BAND / AUTO PROG on the main unit or
TUNER on the remote control to select
between FM or AM Radio band.
Tuning to a Station
Press DIGITAL TUNING or to select
frequencies.
Using Presets
The tuner can be in either TUNE or PRESET mode.
When in PRESET mode, the PROG light is on.
• Press TUNE•PRESET to toggle TUNE and
PRESET mode.
• Press DIGITAL TUNING or on the
main system or FOLDER/PRESET or to
access the previous or next preset station.
The display first shows the preset program
number and after a few seconds, the frequency
will be displayed.
(FMPR:01 is FM preset 1)
Auto Preset Programming
(FM only)
Press and hold the BAND / AUTO PROG button
for 2 seconds to scan stations in FM band. The
stations will then be stored as preset channels. A
maximum of 32 stations can be stored. Beware of
your preset channels being erased accidentally
because the scanning and storing process is
automatic upon pressing the button. You can
stop the automatic scan by pressing any button,
but the erased stations cannot be recovered.
Manually Setting Presets
1. Press the TUNE•PRESET button to enter TUNE
mode.
2. Press DIGITAL TUNING or to access
the desired frequency.
3. Press the PROG•SET button once.
4. The most recently accessed program location
will be displayed.
5. If a different program location is preferred,
press DIGITAL TUNING or on the
main unit or FOLDER/PRESET or to
move to the desired preset number (1-32).
6. Press PROG•SET to store the selected
frequency at that preset.
Suppressing Stereo Signal
Press FM ST to toggle between FM mono and
stereo mode. (Remote Only) “ST” is displayed in
stereo mode.
Tips:
Your audio system has 32 preset stations.
To Next Page
Loading...
Need help?
General
