4
EN
General Controls
Remote Control
—Turns power on or off from STANDBY
mode.
CD — Selects CD player.
TUNER — Selects radio tuner and change radio
band in Tuner mode.
AUX — Selects Aux; turns the system on.
EQ — Selects equalizer presets.
B. BOOST —Turns Bass Boost on or off.
DIMMER / DEMO —Turns the feature
demonstration on or off; adjusts display
brightness.
VOL+ or VOL- — Increases / decreases volume.
PLAY/PAUSE — Plays and pauses current CD.
NEXT /FWD — In CD mode - Skips
forward to the next CD track; In Tuner mode -
Tunes up radio frequency.
PREV /REV — In CD mode - Skips
backwards to the previous CD track;
In Tuner mode - Tunes down radio frequency.
OPEN/CLOSE — Opens and closes CD disc tray.
STOP — Stops playing CD.
REPEAT — Repeats a track, CD, or all CDs.
MUTE - mutes sound.
SHUFFLE —Turns on/off random playback.
FM ST. - Toggles between FM stereo and mono.
DISC SKIP — Skips to next CD.
INTRO - Turns INTRO mode on or off to play the
first 10 seconds of each track.
FOLDER / PRESET / — In Simple
mp3/WMA mode - Goes to the next and previous
folder.
In Tuner mode - Selects next/ previous preset
station.
In Clock or Timer mode - Increases / decreases the
hour or minute digit.
SLEEP - selects the time interval in minutes
before the unit turns off.
Installing Batteries
The remote control must be inserted with 2
“AAA” or “R3” or “UM 4” batteries prior to use.
Follow the steps below to ensure correct
installation.
1. Open the battery compartment door (located
at the back of the remote control) by sliding
the cover out.
2. Before inserting the batteries, observe the
polarities (that is, + and -) of the battery then
relate the polarities to the engraved diagram
inside the battery compartment. Now insert
the batteries.
3. After installation of the batteries, place the lit
to cover the batteries. Lightly push it closed
with a snap
To Next Page
Loading...
Need help?
General
