2
SAFETY INSTRUCTIONS
FCC INFORMATION
This device complies with Part 15 of the FCC
rules. Operation is subject to the following two
conditions:
(1)This device may not cause harmful interference,
and
(2)This device must accept any interference
received, including interference that may cause
undesired operation.
NOTE: This equipment has been tested and found
to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable
protection against harmful interference in a
residential installation. This equipment generates,
uses, and can radiate radio frequency energy
and, if not installed and used in accordance with
the instructions, may cause harmful interference
to radio communications. However, there is no
guarantee that interference will not occur in a
particular installation. If this equipment does
cause harmful interference to radio or television
reception, which can be determined by turning the
equipment off and on, the user is encouraged to try
to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment
and receiver.
• Connect the equipment into an outlet on a circuit
different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio/TV
technician for help.
WARNING:
• Changes or modifications to this unit not
expressly approved by the party responsible for
compliance could void the user’s authority to
operate the equipment.
• The AC adapter is used as disconnect device and
it should remain readily operable during intended
used. In order to disconnect the unit from the
mains completely, the AC adapter should be
disconnected from the mains socket outlet
completely.
• The AC adapter of unit should not be obstructed
OR should be easily accessed during intended
use.
• Minimum 10 cm (4 inches) distances around the
unit for sufficient ventilations.
• The ventilation should not be impeded by
covering the ventilation openings with items
such as newspaper, table-cloths, curtains, etc.
• No naked flame sources such as lighted candles
should be placed on the unit.
ON SAFETY
• Should any objects or liquids fall into the unit,
disconnect the power supply and have the
unit checked by qualified personnel before any
further operation.
• The unit shall not be exposed to dripping or
splashing and that no objects filled with liquid,
such as vases, shall be placed on the unit.
ON USE
Never use the unit where it would be subject to:
- Heat sources such as radiators or air ducts.
- Direct sunlight.
The device has been evaluated to meet general RF
exposure requirement.
To maintain compliance with FCC’s RF exposure
guidelines, this equipment should be installed
and operated with a minimum distance of 20cm
between the radiator and your body.
FOR CUSTOMERS IN CANADA
This apparatus complies with the Class B limits for
radio noise emission set out in radio interference
regulations.
CAN ICES-3 (B) / NMB-3 (B)
This device complies with Industry Canada licence-
exempt RSS standard(s). Operation is subject to
the following two conditions: (1) this device may
not cause harmful interference, and (2) this device
must accept any interference received, including
interference that may cause undesired operation.
To Next Page
Loading...
Need help?
General
