5
MOUNTING INSTRUCTIONS
TOOLS NEEDED: 1) Electric drill with 1/4” bit; 2) Phillips-head (cross style) screwdriver.
STEP 1
If your cabinet does NOT have an overhang:
a) Place the Mounting Template in the desired
location inside or underneath the cabinet
(whichever has less obstructions, and will be
easier for you to reach to drill holes), flush with
the front edge of the cabinet and tape it down.
Go to STEP 2.
If your cabinet DOES have an overhang:
a) Measure the thickness “T” of the cabinet
overhang (see Figure 1).
STEP 3
If your cabinet does NOT have an overhang:
a) Eight screws are included with this unit, but you
will only need four of them. Select the screw
length which will go completely through your
cabinet bottom, and provide at least 3/8” of
thread to screw into the main unit.
b) Insert the four selected screws through each
hole from the inside of the cabinet going
down (see Figure4).
b) Fold the Mounting Template along the guideline
that is closest to the thickness of your cabinet
overhang.
c) Tape Mounting Template to the underside of the
cabinet with the folded portion of the Mounting
Template flush up against the cabinet overhang
(see Figure 2). Go to STEP 2.
STEP 2
Use an electric drill with a ¼” drill bit (not included)
to drill all four holes marked on the Mounting
Template (see Figure 3). To reduce splintering,
place a small piece of masking tape over each
hole location before drilling. Go to STEP 3.
To Next Page
Loading...
Need help?
General
