12 | Installation
2 INSTALLATION
NOTE: The REDARC BCDC Series In-Vehicle chargers are suitable for use on vehicles with
conventional alternator charging systems, including standard, variable voltage and idle stop type
alternators.
2.1 Install Location
The REDARC BCDC Mounting Bracket Series is available to suit a range of common vehicles. The
brackets attach to pre-existing mounting points on the vehicle to facilitate installation of the BCDC,
minimising the need for vehicle modification.
CAUTION
The heatsink can reach around 60°C / 140°F (this is normal and safe operation when the unit
deliver full power or run in hot conditions). The location to install the unit should prevent contact
with the users of the vehicle and not be in contact with highly flammable material.
The unit will operate optimally below 55°C / 130°F with good airflow. At higher temperatures the unit
will de-rate output current up to 80°C / 175°F at which point the unit will turn OFF.
The charger is suitable for mounting in the cabin of the vehicle, along a chassis rail or in the engine
bay (ensure the unit does not become covered by a build up of mud or other). If mounting in an
engine bay, locate the unit away from high temperature areas for maximum performance.
Choose locations such as on the inner guard, behind a headlight or behind the grille to one side of
the radiator.
REDARC recommend keeping the cable length
between the charger and auxiliary battery to less
than 1m. It is important to ensure the charger is
mounted as close as possible to the battery being
charged (auxiliary battery). Certain batteries are
better suited to each of these types of installations
so it is important to select the correct battery
type. For more information consult your battery
manufacturer’s specifications. For example, most of
the lithium type (LiFePO
4
) batteries are not suitable
for engine bay installations. Refer to "Charge Profile
Selection" on page 13 to select the best Charge
Profile for your installation.
The charger should be mounted in any orientation
(so that the front decal is visible) using the 4
mounting tabs provided on the heatsink (refer to
Figure 4.8.1) using suitably sized screws.
Figure 4.8.1: Mounting the Charger
To Next Page
Loading...
Need help?
General
