Troubleshooting | 19
3 TROUBLESHOOTING
There are no LEDs ON at all.
This indicates that there is no battery connected to the output (BROWN wire) or that battery is not
at a suitable voltage level to be charged AND the input (YELLOW/RED wire) of the charger is not
connected.
1. Check all wiring to the charger and battery, particularly the Ground (BLACK wire).
2. Check fuses are intact and properly connected.
If the problem persists, contact your local Auto-Electrician.
The Charge Profile LED is flashing.
This indicates that either Output or Input is not valid, either:
• An Auxiliary battery at a suitable voltage level to be charged is connected to the output of the
charger, however there is currently no valid charging source.
• A valid charging source is available but the Auxiliary battery is not at a suitable voltage level to
be charged or is not connected.
1. Check that the Vehicle (RED wire) and/or Solar (YELLOW wire) are electrically connected.
• The Vehicle (RED wire) should connect directly to the Vehicle battery positive terminal via an
adequately rated fuse.
• The Solar (YELLOW wire) should connect directly to the Solar Panel positive terminal/wire.
2. Check that the Ground (BLACK wire) is connected to the Auxiliary battery and Chassis Earth
and/or the Solar Panel negative terminal/wire.
3. Check all wiring to the Auxiliary battery, particularly the Ground (BLACK wire).
4. Check fuses are intact and properly connected.
If the problem persists, see the relevant points following.
To Next Page
Loading...
Need help?
General
