7
2 INSTALLATION
2.1 Install Location
The charger is suitable for mounting in the cabin of the vehicle, along a chassis
rail or in the engine bay (ensure the unit does not become covered by a build
up of mud or other). It is important to ensure the charger is mounted as close
as possible to the battery being charged (auxiliary battery). Certain batteries
are better suited to each of these types of installations so it is important to
select the correct battery type. For more information consult your battery
manufacturer’s specifi cations.
Lithium type (LiFePO
4
) batteries are not suitable for engine bay installations.
Refer to fi gure 1.2.1 for selecting the best Charge Profi le for your installation.
The charger should be mounted in any orientation (so that the front decal is
visible) using the 4 mounting tabs provided on the heatsink (refer fi gure 2.1.1)
using suitably sized screws.
The unit will operate optimally below 55°C with good airfl ow. At higher
temperatures the unit will de-rate output current up to 80°C where the unit will
turn OFF.
Figure 2.1.1 - Mounting the Charger
To Next Page
Loading...
Need help?
General
