Revision 2.3 Page 10 of 14
Warning
Please Note
The specifications of the product detailed on this
Set-Up Guide may change without notice. RDM
Ltd. shall not be liable for errors or for incidental
or consequential damages, directly and indirectly,
in connection with the furnishing, performance or
misuse of this product or document.
Ensure that all power is
switched off before
installing or maintaining
this product
ML Multistage Thermostat Installation Guide
IP-L
To use the ML controller in IP-L mode, you will require either a PR0016 Mercury IP Module or PR0018 Mercury Hub.
The rotary switches must be set to 000 on the comms module or 00 on the Hub
In this mode the IP address and gateway address must be set up manually in the controller.
Use the following table as a guide: -
Network Mask Length (see table below)
Exit network menu. N.B. this option must be selected to save
any changes made in this menu
Setting nL
To ease setup, a single network mask length value is used. If the address has been specified with a network mask value in dotted IP
format e.g. 255.255.255.0 then the table below gives the conversion:
The network led will start flashing as the controller is logging on to the network; once logged on, the LED stays on.
485 Networks
RS485 Relay Board will support the following protocol :-
Genus
Use the controller menu options to set-up the network; press enter at the “net” screen, then choose from the following network set-up
screens:
Show underlying network address assigned to
controller
Re-log the controller back onto the network
Clear the address/name from the controller
Exit network menu. N.B. this option must be selected to save any changes
made in this menu
To Next Page
Loading...
Need help?
General
