M219 Additional room amplifier
M Series
5
M219- Front view
[A] IR Sensor
The InfraRed sensor receives
signals from the remote control
or from any other IR control
devices, such as the PDAs for
the music server.
Switching the IR sensor off
If required, the IR sensor can be
switched off using the SETUP
DIL switch [3] on the rear of the
M219.
[B] Status LED
[C] Ventilation slots
The ventilation slots on the front
and the top of the M219 must
always be left clear of
obstructions.
The M219 should be installed in
such a way that the ventilation
slots are not covered up and so
that there is a gap of at least
5cm between the unit and any
walls or furniture.
The blue status LED gives information about the current state of the
M219.
LED display M219 Status
Permanently dark M219 standby mode
Permanently lit M219 active
Rapid flashing Breakdown, overload
Rapid flashing Min/max position reached
(Volume, Bass, Treble, Balance)
Slow flashing IR receive (RC5 or RC6 Codes)
Single flash LOCAL 1 or general change of source
Double flash LOCAL 2
Triple flash LOCAL 3
Room-Amplifier
M219
[A] [B] [C]
To Next Page
Loading...
Need help?
General
