2. Press [Cancel Scanning] or [Cancel TX].
Depending on the transmission mode and function you use, either [Cancel Scanning] or [Cancel
TX] is displayed.
Canceling a Transmission After the Original Is Scanned
Use this procedure to cancel a transmission after the original is scanned.
You can cancel transmission of a file while the file is being sent, stored in memory, or if it fails to transmit.
All the scanned data is deleted from memory.
1. Press the [Stop] key.
You can also press [TX/RX Status / Print], and then [Check / Stop Transmission File].
2. Press [Standby File List].
To cancel transmission of a file stored in the memory, press the [File List] tab.
3. Select the file you want to cancel.
If the desired file is not shown, press [ ] or [ ] to find it.
4. Press [Stop Transmission].
To cancel another file, repeat steps 3 through 4.
5. Press [OK].
6. Press [Exit].
After pressing [Check / Stop Transmission File] under [TX/RX Status / Print] in step 1, press [Exit]
twice.
Canceling a Transmission
95
To Next Page
Loading...
Need help?
General
