15
5. Other Information for This Machine
Laser Safety
This machine complies with the requirements of IEC60825-1:2014 for class 1
laser product. The machine contains four 4ch-Laser Diode Arrays (4ch-LDA).
Laser diodes are AlGaInP, 657–663 nanometer wavelength for each emitter. The
beam divergence angle is 16 degrees (minimum) and 25 degrees (maximum)
in the vertical direction, and 7 degrees (minimum) and 13 degrees (maximum)
in the horizontal direction, and laser beams are generated in Continuous Wave
(CW) mode. Each 4ch-LDA has four light sources and the maximum output
power of the light source is 17 milliwatt.
The following label is attached on the rear side of the machine:
Caution
Use of controls or adjustments or performance of procedures other than those
specified in this manual might result in hazardous radiation exposure.
For Users in India
This product complies with the “India E-waste Rule 2011” and prohibits use
of lead, mercury, hexavalent chromium, polybrominated biphenyls or poly-
brominated diphenyl ethers in concentrations exceeding 0.1 weight % and 0.01
weight % for cadmium, except for the exemptions set in Schedule 2 of the Rule.
To Next Page
Loading...
Need help?
General