Roborock Q7+ User Manual

11
C8-4—Install a new dust bag in place along the
slot and put the dustbin cover back.
C9
Air Duct
*
Replace as needed.
C9-1—Unscrew the screws (10) and remove
the cover.
C9-2—Wipe the air duct and cover with a
dry cloth.
C9-3—Re-install the cover and screw it back
in place.
C10-3—Four Cli Sensors
C10-2—Wall Sensor
C10
Robot Sensors
* Clean every month
C10-1— Dock Locator
Use a soft, dry cloth to wipe all sensors,
including:
Basic Parameters
Robot
Note: The serial number is on a sticker on the underside of
the robot.
< 6 hoursCharging Time
Q400RRModel
14.4V/5200mAh
lithium-ion battery
Battery
Approx. 3.2kg (7.05 lbs. )Weight
20V
1.2A
20V
1.2A
Rated Input
Clean the charging contacts of the dock and
the robot with a soft, dry cloth.
C11
Charging Contact Areas
The robot is equipped with a high-
performance lithium-ion rechargeable
battery pack. To maintain battery
performance, keep the robot charged during
normal use.
Battery
Note: If the robot will be left unused for a long period, turn it
o and charge it at least every three months to avoid battery
damage caused by over-discharge.
* Clean every month
Notes:
•
Before removing the battery, make sure it is fully drained.
Do not attempt to remove the battery if the robot is
connected to the dock.
•
Remove the entire battery pack. Avoid damaging the
battery pack casing to avoid short-circuits or leakage of
hazardous substances.
•
In the event of accidental contact with battery uid, rinse
thoroughly with water and seek immediate medical care.
Removing the Battery
Environment
Protection Information
* The following information applies only when disposing
of the robot and should not be followed for day-to-day
operations.
The chemical substances contained in the
built-in lithium-ion battery of this product
can cause environmental pollution. Remove
the battery before disposing of this product
and hand it to a professional battery
recycling facility for centralized disposal.
1. Operate the robot without connecting to
the dock until it runs out of battery.
2. Turn o the robot.
3. Unscrew the battery cover.
4. Remove the battery cover.
5. Press the latch to pull out the battery
connector and remove the battery.
50-60Hz
9.5A
0.5A
Rated Input (Dust Collection)
Rated Input (Charge)
Rated Output
Auto-Empty Dock
AED03LRR, AED04LRR
Model
120V~
Rated Input Voltage
Rated Frequency
Charging Battery
14.4V/5200mAh
lithium-ion battery

Roborock Q7+ Specifications

General

Brand	Roborock
Model	Q7+
Category	Vacuum Cleaner
Language	English