Roborock Q8 Max+ User Manual

11
The chemical substances contained in the
built-in lithium-ion battery of this product
can cause environmental pollution.
Before disposing of this product, remove
the battery. The battery should then be
properly recycled either through local
authorities or by providing the batteries to a
battery recycling facility.
1. Operate the robot without connecting to
the dock until it runs out of battery.
2. Turn off the robot.
3. Unscrew the battery cover.
4. Remove the battery cover.
5. Press the clip to pull out the battery connector.
6. Remove the battery.
How to remove the battery:
Environmental protection
description
Note:
Notes:
The following information is only suitable for the
situation that the robot will be disposed of or its battery
cannot function normally after recharging.
• Before removing the battery, make sure it is fully drained.
Do not attempt to remove the battery if the robot is
connected to the charging dock.
• Remove the entire battery pack. Avoid damaging the battery
pack casing to avoid short-circuits or leakage of hazardous
substances.
• In the event of accidental contact with battery fluid, rinse
thoroughly with water and seek immediate medical care.
Basic Parameters
Robot
Note: The serial number is on a sticker on the underside of
the robot.
Q80ULLModel
14.4V/5200mAh (TYP)
lithium-ion battery
Battery
< 6 hoursCharging Time
Rated Input
20V 1.2A
Auto-Empty Dock
Model
Name
AED06LRR, AED07LRR
Auto-Empty Dock
Rated Input Voltage 120V~
Rated Frequency 50-60Hz
Rated Input
(Dust Collection)
Rated Input
(Charge)
9.5A
0.5A
Rated Output 20V
1.2A
Charging Battery
14.4V/5200mAh (TYP)
lithium-ion battery

Roborock Q8 Max+ Specifications

General

Shape	Round
Product color	Black
Dust container type	Dust bag
Smartphone remote support	Yes
Brush type	Roller brush
Noise level	- dB
Frequency band	2.4 GHz
Navigation type	LiDAR
Wi-Fi standards	802.11b, 802.11g, Wi-Fi 4 (802.11n)
Integrated sensors	Gyroscope
Water tank capacity	0.35 L
Dust capacity (base)	2.5 L
Dust capacity (total)	0.77 L
Dirt separating method	Filtering
HEPA filtration system	No
Floor surfaces supported	Carpet, Hard floor
Automatic base station return	-
Battery capacity	5200 mAh
Package weight	12301 g
Suction power	5500 Pa

Weight and Dimensions

Depth	353 mm
Width	350 mm
Height	96.5 mm
Weight	3600 g
Base station weight	4500 g
Base station dimensions (W x D x H)	440 x 305 x 448 mm