11
Do not touch the surface of the filter with your hands,
brush, or hard objects to avoid potential damage.
*
Clean as required.
*
Clean after each use and replace every 3-6 months.
*
Clean monthly.
*
Clean monthly.
Open the water tank and fill it with
clean water.
Close the water tank and shake it
gently.
Pour out the remaining water as
shown.
Remove the VibraRise mop cloth
from the VibraRise mop cloth mount.
Clean the VibraRise mop cloth and
air-dry it.
Carpet Sensor
Cliff Sensors
Rinse the filter repeatedly and tap it
to remove as much dirt as possible.
Allow 24 hours for the filter to dry
thoroughly and reinstall it.
Note: If the robot will be left unused for a long period, turn it
off and charge it at least every three months to avoid battery
damage caused by over-discharge.
Note:
Note: Purchase an additional filter and alternate if necessary.
C7-1—
C6-3—
C6-2—
Basic Parameters
Robot
Note: The serial number is on a sticker on the underside of
the robot.
< 6 hoursCharging Time
S80ULTModel
14.4V/5200mAh (TYP)
lithium-ion battery
Battery
Rated Input
Charging Dock
14.4V/5200mAh (TYP)
lithium-ion battery
Charging Battery
CDZ12RR or CDZ20RR
Model
28WRated Power
100-240VACRated Input
20VDC 1.2A
Rated Output
50-60HzRated Frequency
C8-1—
Note: A dirty VibraRise mop will affect the mopping
performance. Clean it before use.
Use a soft, dry cloth to wipe and clean all
sensors, including:
Reactive 3D Obstacle Avoidance SensorC9-2—
Wall SensorC9-1—
C9-3—
C9-4—
Use a soft dry cloth to wipe the charging
contacts on the charging dock and the
robot.
Battery
The robot is equipped with a built-in
high-performance lithium-ion rechargeable
battery pack. To maintain battery
performance, keep the robot charged
during normal use.
C7-2—
C7-3—
20VDC 1.2A
C7
Water Tank
C8
VibraRise Mop Cloth
C9
Robot Sensors
C10
Charging Contact Areas
To Next Page
Loading...
Need help?
General
Weight and Dimensions
