07
Installation
B
B1
Position the charging dock
B2
Secure the charging dock
with the adhesive tape
B3
Attach the Moisture-
Proof Mat
Important Information
1. Tidy cables and loose items from the
ground and move any unstable, fragile,
precious, or dangerous items to prevent
personal injury or property damage due
to items becoming tangled in, struck by,
or knocked over by the robot.
2. When using the robot in a raised area,
always use a secure physical barrier to
prevent accidental falls that may result in
personal injury or property damage.
Wipe the floor of the area where the
charging dock will be placed with a dry cloth,
then secure the dock in place using double-
sided tape at the bottom of the dock.
Note: When necessary, remove the double-sided adhesive
tape slowly to reduce residue glue.
Press and hold the button to power on
the robot. When the power light goes on,
place the robot on the dock to charge. Make
sure the charging dock power indicator
turns off and a “charging” voice alert sounds.
To maintain the performance of the high-
performance lithium-ion rechargeable battery
pack, keep the robot charged.
The robot may not turn on when the battery is low. In
this case, place the robot directly onto the dock to charge.
Note:
Power on and charge
the robot
Note: When using the robot for the first time, follow it
throughout its whole cleaning route and watch for potential
problems. The robot will be able to clean by itself in future uses.
Keep the Charging Dock on a level surface,
flat against a wall. Connect the power cable
to the Charging Dock and tidy cables from
the floor. To ensure a better user experience
of the mobile app, place the Charging Dock
in an area with good WiFi coverage.
B1-1 More than 0.5m (1.6ft)
B1-2 More than 1.5m (4.9ft)
After fixing the Charging Dock in place, use a
dry cloth to clean the area where the Moisture-
Proof Mat will be located. Peel off the outer
layer of the double-sided tape attached to the
bottom of the Moisture-Proof Mat, and stick
the mat to the ground as shown.
Notes:
• Always place the Moisture-Proof Mat on wooden floors.
• Peel the double-sided tape slowly to minimize residual adhesive.
• The Moisture-Proof mat attaches best to smooth surfaces.
• Allow at least 0.5m (1.6ft) of clearance on each side, and
more than 1.5m (4.9ft) in front of the Charging Dock.
• If the power cable hangs vertical to the ground, it may
be caught by the robot, causing the Charging Dock to be
disconnected.
• The Charging Dock indicator is on when the Charging Dock
is electrified, and off when the robot is charging.
• Do not place the Charging Dock in places that are directly
exposed to sunlight, or block the Location Beacon.
Otherwise the robot may not be able to automatically return
to the Charging Dock.
Notes:
To Next Page
Loading...
Need help?
General
Weight and Dimensions
