Allen-Bradley, ControlLogix, FactoryTalk, FactoryTalk Analytics, LISTEN. THINK. SOLVE, LogixAI, Rockwell Automation, and Rockwell Software are trademarks of Rockwell Automation, Inc.
Trademarks not belonging to Rockwell Automation are property of their respective companies.
Publication 1756-QS002B-EN-P - April 2020 PN-5
83018
Supersedes Publication 1756-QS002A-EN-P - January 2019 Copyright © 2020 Rockwell Automation, Inc. All rights reserved. Printed in the U.S.A.
Rockwell Otomasyon Ticaret A.Ş., Kar Plaza İş Merkezi E Blok Kat:6 34752 İçerenköy, İstanbul, Tel: +90 (216) 5698400
Rockwell Automation maintains current product environmental information on its website at http://www.rockwellautomation.com/rockwellautomation/about-us/sustainability-ethics/product-
environmental-compliance.page.
Train the Model
1. Save the model as a .L5X file.
The .L5X file contains a user-defined data type (UDT) that you import into the controller project.
2. Open the controller project and import the UDT.
You must have the programming software to edit the controller project.
3. Set the .TRAIN tag = 1.
The tag is reset = 0 when training is complete.
Complete training during normal system operation so that anomalous
operation can be detected later.
4. Repeat setting the train tag as many times as needed, until the confidence
in the results is sufficient.
Start Calculations
Once training is complete, that is, when the .State tag = 2, start the analytic
calculations.
1. Set the .Calculate tag = 1.
2. To determine appropriate system actions, monitor the results.
To Previous Page
Loading...
Need help?
General
