EasyManuals Logo
Home>Rockwell Automation>Touch terminals>PanelView Plus 700

Rockwell Automation PanelView Plus 700 Installation Instructions

Rockwell Automation PanelView Plus 700
32 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #8 background imageLoading...
Page #8 background image
8 PanelView Plus 700 to 1500 and PanelView Plus Compact 1000 Terminals and Display Modules
Publication 2711P-IN001I-EN-P - November 2009
Wiring and Safety Guidelines
Use publication NFPA 70E, Electrical Safety Requirements for Employee Workplaces, IEC
60364 Electrical Installations in Buildings, or other applicable wiring safety requirements for
the country of installation when wiring the devices. In addition to the NFPA guidelines:
connect the device and other similar electronic equipment to its own branch circuit.
protect the input power by a fuse or circuit breaker rated at no more than 15 A.
route incoming power to the device by a separate path from the communication lines.
cross power and communication lines at right angles if they must cross.
Communication lines can be installed in the same conduit as low-level
DC I/O lines (less than 10V).
shield and ground cables appropriately to avoid electromagnetic interference (EMI).
Grounding minimizes noise from EMI and is a safety measure in electrical
installations.
For more information on grounding recommendations, refer to the National Electrical Code
published by the National Fire Protection Association.
For more information, refer to Wiring and Grounding Guidelines for PanelView
Plus/PanelView Plus CE Devices Technical Data, publication 2711P-TD001
. You can find
this publication in the Literature Library website, http://literature.rockwellautomation.com
.
About the PanelView Plus 700 to 1500 Terminals
The PanelView Plus terminals have these modular components:
Display module (700, 1000, 1250, and 1500)
Logic module with AC or DC power, CompactFlash card slot, Ethernet port, serial
port, and USB ports
Internal CompactFlash card with firmware or operating system, RAM memory
(SO-DIMM)
Communication module for specific communication protocols
These items can be ordered as separate components for field installation or factory assembled
per your configuration. The base-configured unit includes the display module and the logic
module with internal CompactFlash and RAM.

Other manuals for Rockwell Automation PanelView Plus 700

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Rockwell Automation PanelView Plus 700 and is the answer not in the manual?

Rockwell Automation PanelView Plus 700 Specifications

General IconGeneral
BrandRockwell Automation
ModelPanelView Plus 700
CategoryTouch terminals
LanguageEnglish

Related product manuals