118
Saving all current settings
Here’s how you can save (write) all the
following currently selected settings.
If you’ve been editing these settings in parallel,
it is convenient to use this method to write all
settings in a single operation, instead of having
to move to the Write screen for each group of
settings.
1. Hold down [SHIFT] and press [WRITE]
([REC]).
The Write All setting screen appears.
For settings that have been edited, the
number and name are displayed. “- - - -” is
shown for settings that have not been edited.
fig.07-200d
2. Move the cursor to the write destination
for each item of data, and use the VALUE
dial to select a number.
If you want to write your settings as user
data, select “U**.”
If you don’t want to write a certain item,
choose “----”.
* If a preset is currently selected, the write destination will
initially be a preset number.
If you attempt to carry out the Write procedure in this
state, the message “Select user ***.” will appear, and the
data will not be written.
You must change the write destination to a user memory
number or “- - - -.”
3. To write the data, press [ENTER].
If you decide to cancel, press [EXIT].
The message “Now writing...” will appear,
and the currently selected settings will be
written.
When the currently selected settings have
been written, the message will disappear.
* Do not turn off the power while the message is displayed.
Your data may be damaged if you do so.
Settings Write destination
Pattern or song User pattern/song
Kit User kit
TSC TSC user patch
Guitar effects Guitar effects user patch
To Next Page
Loading...
Need help?
General