18
Before you begin playing
* To prevent the inadvertent disruption of power to your unit (should the plug be pulled out
accidentally), and to avoid applying undue stress to the AC adaptor jack, anchor the power cord
using the cord hook, as shown in the illustration.
fig.002-020
1
Before you start making connections, check the following:
• Have you turned down the volume controls of the DR-880 and the connected amp or
other equipment?
• Have you turned off the power of the DR-880 and the connected amp or other
equipment?
2
Connect your amp or audio system (or headphones) as shown in the diagram.
We recommend that you use a stereo playback system in order to take full advantage of the
DR-880’s capabilities.
If you are using the DR-880 with a monaural playback system, connect it to the OUTPUT L
(MONO) jack.
■ Turning the power on
Once the connections have been completed (p. 17), turn on power to your various devices
in the order specified. By turning on devices in the wrong order, you risk causing
malfunction and/or damage to speakers and other devices.
1
Before you turn on the power, check the following:
• Is the DR-880 correctly connected to your other equipment?
• Have you turned down the volume of the DR-880 and your connected amp or playback
system?
2
Turn on the POWER switch located on the DR-880’s rear panel.
fig.002-030
Turning the power on/off
To Next Page
Loading...
Need help?
General