19
Before you begin playing
The following appears in the display, and the unit switches to performance mode.
The screen that appears at that point is called the “Pattern Play screen.”
fig.002-031d
This unit is equipped with a protection circuit. A brief interval (a few seconds) after power
up is required before the unit will operate normally.
3
Turn on the power of your amp and other connected equipment.
4
Press [ ].
Playback will begin.
While listening to the playback, turn the MASTER VOLUME knob and PART LEVEL
(DRUM, BASS) knobs to adjust the DR-880’s volume.
fig.002-040
Adjust the volume appropriately on your connected amp or playback system.
5
Press [ ] to stop playback.
■ Turning the power off
1
Before you turn off the power, check the following:
• Have you turned down the volume of the DR-880 and your connected amp or playback
system?
2
Turn off the power of your amp or connected playback system.
3
Turn off the power of the DR-880.
To Next Page
Loading...
Need help?
General