119
Chap. 8
System settings
Adjusting the output signal
(Output Setting)
Here you can make final settings before the
signal is sent from MASTER OUT.
1. Press [OUTPUT SETTING].
The Output Setting screen appears.
fig.07-030d
2. Use [CURSOR] / to select the
desired screen.
3. Move the cursor to the parameter you
want to edit, and use the VALUE dial to
specify the value.
■ MASTER
fig.07-030d
■ GUITAR
fig.07-050d
* If you select IND. A+B, IND. A, or IND.B, the following
parameter is displayed.
4.
When you’ve made the setting, press [EXIT].
The message “Now writing...” will appear,
and the currently setting will be saved.
Parameter/
Range
Explanation
Output Sel
GUITAR AMP,
LINE/PHONES
Specify the device connected to the
MASTER OUT jacks
GUITAR AMP:
Choose this if a guitar amp is connected
LINE/PHONES:
Choose this if an audio system or recorder is connected,
or if you’re listening through headphones connected to
the PHONES jack
D. Out Lev
0–200%
Adjust the level of the digital audio
signal sent from the DIGITAL OUT
jack
Low EQ
-20–+ 20 dB Low range boost/cut amount
High EQ
-20–+ 20 dB High range boost/cut amount
Ambience
0–200% Ambience volume
Parameter/
Range
Explanation
Out Assign
MASTER,
IND. A+B
IND. A, IND. B
Specify the jack(s) from which the
sound from the GUITAR/BASS IN-
PUT jack will be output
MASTER:
Output from MASTER OUT
IND. A+B:
Output from INDIVIDUAL A/B
IND. A:
Output from INDIVIDUAL A
IND. B:
Output from INDIVIDUAL B
Parameter/
Range
Explanation
Output Sel
GUITAR AMP,
LINE/PHONES
Specify the device connected to the
INDIVIDUAL A/B jacks
GUITAR AMP:
Choose this if a guitar amp is connected
LINE/PHONES:
Choose this if an audio system or recorder is connected,
or if you’re listening through headphones connected to
the PHONES jack
Parameter/
Range
Explanation
To Next Page
Loading...
Need help?
General