27
Chapter 4 Other Functions
2.
Turn off the power of the GR-20, and then hold down the
[PATCH EDIT] button while you turn the power on
again.
The display will indicate “dP.”
fig.4-03(DUMP)
3.
Begin recording on the external device that will receive
the data.
If you want to transfer data between two GR-20 units,
put the receiving GR-20 in the Bulk Load (p. 27) Ready
state.
4.
Press the [WRITE] button.
The data will be transmitted from MIDI OUT to the
external device.
During transmission, the display will show the following.
fig.4-031
When the display returns to “dP,” transmission has been
completed.
5.
Stop recording on the receiving device.
6.
Turn off the power.
Loading Patches and System
Parameter Settings From an
External Device (BULK LOAD)
Here’s how GR-20 settings saved via Bulk Dump on an
external device can be loaded back into the GR-20 via MIDI.
Performing the BULK LOAD operation will rewrite all the
data in the GR-20. Be aware that all currently existing data
will be lost.
1.
Connect your external device’s MIDI OUT to the GR-20’s
MIDI IN.
2.
Turn off the power of the GR-20, and then hold down the
[PATCH EDIT] button and turn the power back on again.
The display will indicate “dP.”
3.
Using the [NUMBER/VALUE] knob, get “Ld” to appear
in the display.
fig.4-04(LOAD)
4.
Transmit the data from your external device.
During transmission, the display will show the
following, and the decimal point of the display will
blink.
fig.4-041
When the decimal point of the display stops blinking,
and the display again shows “Ld,” reception has been
completed.
5.
Press the [WRITE] button.
* If the power of the GR-20 was turned off while the data was
being received, the transmitted data will not be written into
the GR-20. If necessary, perform the Bulk Load operation once
again.
6.
Press the [EXIT] button to return to Play mode.
Lit
GR-20_e.book 27 ページ ２００７年７月２日 月曜日 午後１２時５３分
To Next Page
Loading...
Need help?
General
