8
Getting Familiar
D BEAM
Now pass your hand over the D Beam. Here you are simply triggering a sound with it.
Make sure the [D BEAM] button is lit.
Ambience
Next, while holding down the [SHIFT] button, press the [EFFECT] button. This is how you turn the Ambience
on or off, and you will see the indication in the display.
Effects
Press the [SFX] kit button (#5).
Play the pads and D Beam. Press the [EFFECT] button to hear the difference.
Control Knob
TUNING: Press the [STEEL DRUM] kit button (#3).
Now, push the Control Knob, LED
next to TUNING will light. Tap any pad, and turn the control knob. This is
a quick way to tune the sounds.
MUFFLING:
Press the Control Knob and the LED next to MUFFLING will light. Tap any
pad and turn the Control knob.
EFFECT:
Press the Control knob and the LED next to EFFECT will light. Tap any pad
and turn the Control knob. In this case, you are changing a parameter in
the Effects assigned to this kit.
* If you make any of the above adjustments while in a User Kit (1–64), those changes will be written. You
can undo them however. (see page 23)
Preset KIT Buttons
KIT Buton
Control Knob
SHIFT Button
EFFECT Button
D BEAM Button
D BEAM Controller
Press the [KIT] button and try out some of the 64 user kits.
HPD-10_e1.book 8 ページ ２００６年４月７日 金曜日 午後２時１４分
To Next Page
Loading...
Need help?
General
