EasyManua.ls Logo

Roland HS-5 User Manual

Roland HS-5
15 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #13 background imageLoading...
Page #13 background image
13
IMPORTANT: THE WIRES IN THIS MAINS LEAD ARE COLOURED IN ACCORDANCE WITH THE FOLLOWING CODE.
BLUE:
BROWN:
As the colours of the wires in the mains lead of this apparatus may not correspond with the coloured markings identifying
the terminals in your plug, proceed as follows:
The wire which is coloured BLUE must be connected to the terminal which is marked with the letter N or coloured BLACK.
The wire which is coloured BROWN must be connected to the terminal which is marked with the letter L or coloured RED.
Under no circumstances must either of the above wires be connected to the earth terminal of a three pin plug.
NEUTRAL
LIVE
For the U.K.
For the USA
FEDERAL COMMUNICATIONS COMMISSION
RADIO FREQUENCY INTERFERENCE STATEMENT
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
– Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation.
This equipment requires shielded interface cables in order to meet FCC class B limit.
Any unauthorized changes or modifications not expressly approved by the party responsible for compliance could void the user’s
authority to operate the equipment.
WARNING
This product contains chemicals known to cause cancer, birth defects and other reproductive harm, including lead.
For C.A. US
(
Proposition 65
)
For Canada
CAN ICES-3 (B)/NMB-3 (B)
For Korea
For the USA
DECLARATION OF CONFORMITY
Compliance Information Statement
Model Name :
Type of Equipment :
Responsible Party :
Address :
Telephone :
HS-5
AUDIO MIXER
Roland Corporation U.S.
5100 S. Eastern Avenue Los Angeles, CA 90040-2938
(323) 890-3700
For EU Countries
For China
Question and Answer IconNeed help?

Do you have a question about the Roland HS-5 and is the answer not in the manual?

Roland HS-5 Specifications

General IconGeneral
Sample rate44.1 kHz
Frequency range20 - 20000 Hz
Channels quantity- channels
Digital sound processing24 bit
Microphone inYes
Product colorBlack
Video capabilityNo
USB connector typeUSB Type-A, USB Type-B
Fuse1.2 A
Cables includedAC
Weight and Dimensions IconWeight and Dimensions
Depth248 mm
Width257 mm
Height68 mm
Weight1100 g

Summary

Panel Descriptions

Making Connections

Turning the Power On/Off

Provides step-by-step instructions for powering the HS-5 and connected equipment.

Connecting Your Equipment

Guides on connecting various audio sources like microphones, guitars, and headphones.

Basic Operation

Selecting the Input Type

Headphone Output Control

Volume Balance and Output Level

Adjusting the mix balance for performers and the overall headphone output volume.

Recording and Playing Back a Performance

Recording a Performance

Steps for recording audio performances onto a USB flash drive.

Playing Back the Performance

Guidance on how to playback recorded audio from a USB flash drive.

Making Detailed Settings

Connecting Two HS-5 Units

Using the Unit Safely

Power, Auto Off, and Placement Safety

Covers safe power handling, auto-off function, and secure unit placement precautions.

Electrical, Handling, and Factory Reset

Safety guidelines for electrical connections, unit handling, and factory reset procedures.

Related product manuals