125
Adding Effects
This section explains the procedures and settings for applying effects
in each mode.
For details of the JUNO-G’s onboard effects, refer to
About the
Onboard Effects
(p. 20).
The JUNO-G’s onboard effects can be turned on/off as a whole.
Turn these settings OFF when you wish to listen to the unprocessed
sound as you create a sound, or when you wish to use external
effects processors instead of the built-in effects.
* Effect ON/OFF settings are global JUNO-G settings. These settings
cannot be made for each Patch or Performance individually.
1.
Press EDIT [EFFECTS] to access the EFFECT ROUTING
screen.
fig.Routing*
2.
Press [F6 (SWITCH)].
The EFFECT SWITCH window appears.
fig.FxSw
3.
Press [F1 (MFX1)]–[F6 (MASTER)] to turn each effect switch
on/off.
The switch will turn on/off each time you press the button.
4.
Press [EXIT] to return to the previous screen.
When you return to the PLAY screen, the settings will be
displayed in the following area.
fig.FxSw2
1.
In the appropriate mode, select the sound to which you
want to apply effects.
2.
Press EDIT [EFFECTS] to access the EFFECT ROUTING
screen.
3.
Press [F1 (ROUTING)]–[F5 (MASTER)] to select the effect
that you want to edit.
4.
Use the VALUE dial or [INC] [DEC] to set the effect type you
want.
5.
Use [ ] [ ] [ ] [ ] to move the cursor to the parameter
you wish to change.
6.
Use the VALUE dial or [INC] [DEC] to get the value you
want.
7.
Press [EXIT] to return to the previous screen.
* You cannot edit the effect settings for patches of the GM group.
Turning Effects On and Off
Making Effect Settings
JUNO-G_e.book 125 ページ ２００６年２月１３日 月曜日 午後２時４４分
To Next Page
Loading...
Need help?
General
