Roland JUNO-G User Manual

178
Using a Memory Card
The JUNO-G features a PC card slot, allowing you to use
CompactFlash or SmartMedia via the appropriate PC card adaptor.
Make sure that the correct side of the card is facing upward, and
insert it into the JUNO-G’s PC card slot. When you need to remove
the card, press the eject button located beside the card.
fig.MemCard1.e
Patches, rhythm sets, performances, samples, and song data can be
written to the card. For details on the writing procedure, refer to the
explanation for the corresponding parameters.
The JUNO-G provides a PC card protector to prevent theft of the
memory card. To install the PC card protector, use the following
procedure.
1.
Use a screwdriver to remove both of the screws from the
bottom side of the PC CARD slot.
2.
Insert the memory card into the PC CARD card slot.
3. Use the screws to fasten the PC card protector as shown
below.
fig.MemCard2.e
Before Using the Memory
Card
Writing data to the card
Installing the PC Card
Protector
memory
card
Eject
PC card protector
Memory card
JUNO-G Rear Panel
JUNO-G_e.book 178 ページ ２００６年２月１３日 月曜日 午後２時４４分

Roland JUNO-G Specifications

General

Brand	Roland
Model	JUNO-G
Category	Synthesizer
Language	English