43
Creating a Patch
TVA ENVELOPE
Parameter marked with a “
★
” can be controlled using specified MIDI messages
(Matrix Control, p. 44)
Parameter Value Explanation
Random Pan Depth 0–63 Use this parameter when you want the stereo location to change randomly each time you press a key.
Higher settings will produce a greater amount of change.
Alter Pan Depth L63–0–63R This setting causes panning to be alternated between left and right each time a key is pressed.
Higher settings will produce a greater amount of change. “L” or “R” settings will reverse the order in which the pan
will alternate between left and right. For example if two tones are set to “L” and “R” respectively, the panning of the
two tones will alternate each time they are played.
* When any value from Type “2”–”10” is selected for the Structure parameter in the Pan KF, Rnd Pan Depth, Alter Pan Depth
parameter settings, the output of tones 1 and 2 are joined in tone 2, and the output of tones 3 and 4 are joined in tone 4. For this
reason, tone 1 will follow the settings of tone 2, and tone 3 will follow the settings of tone 4 (p. 35).
Parameter
Value Explanation
A-Env T1 V-Sens
-63– +63 This allows keyboard dynamics to affect the T1 of the TVA envelope.
If you want Time 1 to be speeded up for strongly played notes, set this parameter to a positive (+) value. If you
want it to be slowed down, set this to a negative (-) value.
A-Env T4 V-Sens -63– +63 Use this parameter when you want key release speed to affect the T4 value of the TVA envelope.
If you want T4 to be speeded up for quickly released notes, set this parameter to a positive (+) value. If you
want it to be slowed down, set this to a negative (-) value.
A-Env Time KF
(Time Keyfollow)
-100– +100 Use this setting if you want the TVA envelope times (T2–T4) to be affected by the keyboard location. Based on
the TVA envelope times for the C4 key (center C), positive (+) settings will cause notes higher than C4 to have
increasingly shorter times, and negative (-) settings will cause them to have increasingly longer times. Larger set-
tings will produce greater change.
A-Env Time 1–4
★
0–127
TVA envelope times (T1–T4)
Higher settings will lengthen the time until the next volume level is reached.
A-Env Level 1–3 0–127 TVA envelope levels (L1–L3)
Specify how the volume will change at each point, relative to the Tone Level value.
C4C3C2C1 C5 C6 C7
0
+50
+100
-50
-100
o
L
R
Pan Pan Keyfollow
Key
T1 T2 T3 T4
L3
L1
L2
Note off
Level
TVA Envelope
Time
Note on
C4C3C2C1 C5 C6 C7
0
+50
+100
-50
-100
Key
Time
Time Keyfollow
JUNO-G_e.book 43 ページ ２００６年２月１３日 月曜日 午後２時４４分
To Next Page
Loading...
Need help?
General
