47
Editing Using Only the JV-1010
Quick Start
■ Initializing the Settings (Initialize)
This restores the currently selected performance and rhythm set to standard
settings.
fig.1-33
1
Press the VALUE knob and choose the Performance mode
(PERFORM) or the Rhythm Set mode (RHYTHM).
Pressing the VALUE knob makes the mode change sequentially. Press the
knob several times until the PERFORM or RHYTHM indicator lights up.
2
While holding down the VOLUME knob, press the VALUE
knob.
Switch to the Edit mode.
3
Turn the CATEGORY/BANK knob to choose GUITAR/BASS
(Initialize).
int flashes on the display.
4
Press the VALUE knob.
Sur flashes in the display; this is a prompt for you to confirm whether or not
you want to execute Initialize.
fig.Sur
5
Press the VALUE knob.
Initialize is executed, and the JV-1010 exits Edit mode.
32 1,4,5
The GM Initialize operation
affects only the currently
selected data; no data
stored in the user memory
is initialized. If you want to
restore all settings to their
factory values, carry out
Factory Reset (p. 21).
When in the Patch mode,
you can’t enter the Edit
mode.
To exit Edit mode without
executing Initialize, carry
out the operation described
in Step 2.
To Next Page
Loading...
Need help?
General
