7
Connections/Turning On the Power
fig.panel2
* Once the connections have been completed, turn on power to your various devices in the order
specified. By turning on devices in the wrong order, you risk causing malfunction and/or
damage to speakers and other devices.941
1
Make sure that all volume controls on the PM-10 and connected devices are
set to “0.”
2
Turn on the devices connected to the V-DRUMS Input Jack and LINE Input
Jack.
3
Turn on the PM-10’s POWER switch.
* Always make sure to have the volume level turned down before switching on power. Even
with the volume all the way down, you may still hear some sound when the power is switched
on, but this is normal, and does not indicate a malfunction.
4
Adjust the volume levels for the devices.
Connections
Turning On the Power
STEREO MINIATURE PHONE TYPE STEREO 1/4" PHONE TYPE
Percussion Sound Module
CD Player
PHONES
OUTPUT L (MONO)
HEADPHONES OUT
LINE OUT
To prevent malfunction and/
or damage to speakers or other
devices, always turn down the
volume, and turn off the
power on all devices before
making any connections.921
When connection cables with
resistors are used, the volume
level of equipment connected
to the INPUT may be low. If
this happens, use connection
cables that do not contain
resistors, such as those from
the Roland PCS series.926a
This unit is equipped with a
protection circuit. A brief
interval (a few seconds) after
power up is required before
the unit will operate normally.
942
If you need to turn off the
power completely, first turn
off the POWER switch, then
unplug the power cord from
the power outlet. Refer to
Power Supply (p. 5).945
PM-10_e.book 7 ページ ２００７年７月１９日 木曜日 午前１０時２１分
To Next Page
Loading...
Need help?
General
